by Gigi » February 8th, 2021, 1:56 pm
I am glad the reset appeared. It is the first thing I go to whenever things don't seem "quite right" - which thankfully is rare.
As for your question about calibration, I assume you have used the calibration method through SCAL. The best way to get accuracy is to adjust the x and y there if your print and cuts are not accurate or as accurate as you might like them. You can also move the registration marks closer to see if that helps - which for some reason I think you did already. Just be sure you recalibrate every time you change something. As long as you don't change anything in between, your calibration, once perfected, should stay that way.
Not sure I understand what you mean about making changes to the #3 registration mark. You set your calibration at the "cross" that is cut to get an exact cut. Then when you go through the registration marks, there is always an adjustment - I mean you manually move the machine so the laser is directly over the registration mark each time. So each time you do a print and cut, you will align the registration marks - so there should be no "adjustment" to any of the marks. Can you explain more what you mean? Thanks.
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi