Okay, I pulled out my cutter, and set it up (other than adding the tables at this time), and had to pull out the manual to remember how to do anything.
I did manage to load the mat and do a test cut on computer paper. Have not hooked it up to my computer yet as I need to load SCAL onto my Laptop yet. I am going to have to do some practice cuts on paper before I try fabric or cork and get back into the swing of using my Bullet again. I don't remember how to get to the Learning Center, and I think I can remember my sign on info (but will request again if what I'm thinking it is doesn't work). So could someone please let me know the link to the Learning Center.. I will be forever grateful. It has been way to long since I last used my cutter that I can't remember much about how to get it set up. I am looking forward to relearning all about this machine again.