Hello Everyone,
I just purchased my Foil Master and tried it out for the first time.
I tried foiling on matte stock white and a dark coloured stock, metallic cardstock and a metallic envelope so far.
I am using a colour laser printer and foils from Sherri.
The results were not so good.... None of the papers got an even finish of the foil. Is it because I am using a colour laser printer instead of monochrome? (I just want to check in before I go ahead and purchase another printer).
Also, have any of you had experience with metallic stocks? Seems that there might be something in the metallic paper that is also taking some of the foil as it left a darker almost dirty looking tone to the paper where the foil piece was.
The dark cardstock I used had a very fine texture to it, is that also a problem? (This cardstock took the least amount of foil).
Finally, the envelope was a mess due to the heat, so, that is definitely not something that can be foiled.
Any experience or recommendations would be greatly appreciated.
Anita