Hello there,
I have been using the Silver Bullet Cutter for a while now and have not had any problems until now. The designs have always come out beautifully and there were no problems whatsoever even with very detailed patterns.
Last week though I had to start using the Silver Bullet Cutter on a different Mac and I have had the following problems:
- The first item gets cut out very slowly and the blade seams to tear rather than cut through the paper
- From the second item onward the designs are cut out properly and with the right speed, but the cutter stops in irregular intervals and only continues after quite a while
- The blade doesn't go back to the beginning after being finished and stops in the middle of the paper sheet with the laser turned on, but nothing happens until I turn it off
I have gone through different blades, mattes, distances and types of paper and played around with the SignCut settings, but there has been no improvement.
Is this a problem with SignCut or is there some point I am missing?
Thanks for helping me