by Gigi » July 27th, 2017, 7:15 am
If you hadn't just changed your blade, I would say you might have a nicked blade. I would still check it to be sure. It could also be your design. If the nodes are not done well in the design you could have it pull at a corner. You could also have the blade too low or the vinyl might not be well brayered. Have you tried cutting without the mat? Can you cut just a simple square and circle with clean cuts? I would be sure to have success there first. Once you are doing that well, try the file again. That would help eliminate whether or not the file is at issue. Is this the first problem you have had? Just trying to narrow it down.
If you want to attach your design, we can look at it and I am happy to test cut it to see if I have an issue with the design.
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi