Hi folks,
Quick newb question, so sorry if it's been raised previously (I've had a good look, using the search, along with a look through pages of topics, and can't find anything - do I need SpecSavers? )
My issue is in cutting a plain triangle in vinyl, which has some detailed text, so I'm using a 60 degree detail blade, slow speed (60) and relatively low force (30). The detail blade holder is set so that the tip of the blade is just barely showing.
These settings work just fine for the bottom half of the design, but when cutting the top, the blade doesn't seem to be cutting as deeply (ie it doesn't cut all the way through the vinyl, like it did with the lower part of the design).
By the time it reaches the top tip of the triangle, it's hardly cutting at all.
Is this something that's been experienced by anyone else, and - more importantly - does anyone hve a solution, please'?
The picture I've attached shows where the tip of the triangle should be...but isn't!