I think I finally decided on what software to get for my new Lynx (hopefully getting here this month! ). After much research I think that Inkscape/Signcut is going to work for me. I downloaded Inkscape and have been playing with it (loved it!). I never had SCAL or MTC so I have no issues with learning new software. What finally sold me was the Print-and Cut already being there and the engraving discussion!
Anyway, I have some questions:
Is the best place to get Signcut from their site or can I get this from Dawn/Sherri?
Do most people get the 1yr subscription and re-new or outright purchase the Hobby edition?(just curious)
Am I correct that if I purchase the Hobby edition this still has a dongle associated with it?
Now, while reading the Signcut web site they had a list of drivers for the cutters they support, Black Cat was not listed. Is there a separate driver that I would need once I get the software? If so, where would I get this?
I know that this is a lot of questions, but I am just learning. I appreciate any input as I know that this forum is populated by very helpful and knowledgeable people.
Thanks again and hugs,
Martha