Hello Folks; this is my first post on this forum. I hope someone can be of help.
About a month ago, I successfully performed a print and cut of a 17 1/2"-wide graphic on my 18" Silver Bullet.
Unfortunately, today I can't seem to replicate my earlier success. The problem lies in not obtaining the proper placement of the graphic in the cutter. I keep getting the dreaded "pause" message on this device, indicating I've gone out of bounds for cutting.
Anyone have a suggestion on where I should line up the right side of my graphic? Since the cutter is ruled, giving a suggestion using the nearest tenth of a centimeter would be great. Keep in mind that too far to the right causes a failure due to the laser pointer being further to the left than the cutting blade.
Thanks in advance. Mapmeister, maker of 3D maps.