Hey there guys!
So I've had my Silver Bullet for a week or two now, and have made many successful packaging samples at this point! Yay! But the issue is...
Suddenly my cuts are not going all the way through and randomly curving, as if my offset values and overcut values are off!
Cutting Specs:
60 Plus Long Blade
Offset: .7mm
Overcut: 1.2mm (figured that one out after scouring the forums. Booklet should specify since it's the only one more than 1mm, but didn't fix my issue)
Single-Pass
v300
f100
I have used these settings many times and it's suddenly not working.
What I've tried to correct it:
Resetting Silver Bullet Machine
Resetting SCAL4 Settings and Reopening
Verified no debris in standard blade holder
Replaced Blade
Verified material isn't moving/Mat is sticky enough still
Help!