Silver Bullet Cutters Forum

This short tutorial goes through the installation and use of the Eggbot Extension for Inkscape. This extension is very easy to use allows for fills and crosshatches within Inkscape and is useful for both engraving and embossing.

I hope this helps!

Thanks Tyler!!

Thanks will have to look at it later when I am on my computer. I started to install it when I realized I'm on Abby's laptop.LOL

Thanks Tyler, can I post it in my forum too?

Thanks Tyler it will be very handy.
Barbara

Tyler many thanks! Anything written for me is such a great thing ! I know these .pdf's are not easy to write and they take precious time you don't have.

Pat

Of course, Dawn - anything I write here is free game to take to your forum!

Here is a different version that goes through how to manually install and use the extension.

Thanks Tyler. I have it loaded and wanted to use it. Thanks

Thanks Tyler!

Retta wrote:Thanks Tyler. I have it loaded and wanted to use it. Thanks

Ditto what Retta said - had not clue how to use it so thanks again!!

Thanks Tyler! When I figure out how to use inkscape, then I can learn to use this as well.