by Gigi » July 18th, 2015, 10:04 am
You would go to Effects in the software and use the Line Fill and experiment with that until you get the coverage that you want/need. There is also a Cross Hatch setting there that many of us use to engrave, but the line fill should work well to fill the shape for you - I would think.
You could also go to Effects then Shadow Layer and use the Inset Shadow (which might work better if you have a shape with curves and make repeated Inset Shadows until the image is full.
I have not tried it, but thinking that might work best - depending on the look you want in the end.
Hope that helps.
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi