by Gigi » April 14th, 2015, 11:04 am
That will depend on how wide your printer will cut and each printer is a little different. When you do a preview you will see where the registration marks will be. So the print and cut will do a full 24" but you need to account for the registration marks when you are calculating that......
And also remember that the distance is measured from the right of the machine to the left, so your 24 inches will be from where the blade holder sits over.......24" to the left.
Hope that makes sense! And if need be, you can set your registration marks closer than the default. It won't make a lot of difference, but it will give you a little more room to "play"...
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi