Silver Bullet Cutters Forum

Hi all,

How wide can you print and cut on a 24 inch machine. I believe I have to account for where the laser is located. I will just play with it but thought maybe someone was on that knew the answer. Loving my Silver Bullet. Thanks

That will depend on how wide your printer will cut and each printer is a little different. When you do a preview you will see where the registration marks will be. So the print and cut will do a full 24" but you need to account for the registration marks when you are calculating that......
And also remember that the distance is measured from the right of the machine to the left, so your 24 inches will be from where the blade holder sits over.......24" to the left.

Hope that makes sense! And if need be, you can set your registration marks closer than the default. It won't make a lot of difference, but it will give you a little more room to "play"...

Thank you very much Gigi! It totally makes sense. You are always so helpful.

Thank you, Pamela. Glad it made sense and helped. Good luck. Would love to see what you are creating when you are ready to share!