Hi! I've re-posted here as the post I jumped in on was quite old and had no replies (I've just realised :/ )... hope that's OK...
>>>I'm jumping in on this post because I'm having the same problem, plus the whole cut is consistently about 3 mm to the right of where it should be when using WYSIWYG.
I have tried Reset (more than once), I have reinstalled SCAL, I have reinstalled the machine's driver and double-checked the settings. These 3 cuts were made with a new blade. I've tried cutting with more/less pressure and would say using more pressure increases the incidence of the problem slightly. I would say the blade holder is firm and secure in the clamp but it's almost as if the blade is bending? I'm not sure what to try next... ?
Many thanks in advance for any suggestions!<<<