Silver Bullet Cutters Forum

Good Afternoon All,
Please I need some help. All of a sudden my 13"courgar will not cut all the way across the mat. It cuts whatever I have on the first 6"of the mat. In other words when placing the mat into the machine it will cut at the beginning but when moving on into the machine it just pretends to cut. And all it does is leave an indentation of whatever it was supposed to be cutting.
I hope some of you very clever people can help or point me in the direction where I can get help. This is a waste of a good machine if not completely usable.
Thanks in advance
Ana

Check your blade holder and make sure it is clamped into the arm securely. it it is not tight it will slide up and you wont notice it.

Also be sure your mat is level and the material is well brayered onto the mat.

Thanks everyone. I guess when i changed the blade I must have done something. I took the blade out and did it again and tighten it and it seems to be working well now. Sorry to be such a pest. But appreciate the help

You are not a pest. Glad you figured it out and all is well.