by morgan.driessens » September 3rd, 2014, 12:40 am
Hi Guys,
My name is Morgan and I'm a newbie to the forum. I just bought a Silver Bullet Pro 24" and I've been trying to get the hang of it.
In saying that, I think the best way to put forward my question is to show an example.
Basically, when I'm doing vinyl cutting in Sure Cuts a Lot 3, for some reason, on each object (especially when I'm cutting the same sticker multiple times in a line), it will forget to cut the same line, or miss it by a couple of millimetres, so have to cut each image in multiple spots with a scalpel to fix up each bit (near impossible to do on black vinyl.) I've attached a picture of what I mean. Basically I have to hand-cut a horizontal line on the "R" and the second "S" (You can tell which one by my dodgy scalpel cut), retrim the top of the "K" each time because it cuts about 1.5mm above where it should, and also as I've shown with the blue guides above, when I cut, the horizontal lines are inconsistent through the letters "B, E & S" in Bikes, as well as multiple locations in Expressive. I've also found that it has a tendency to actually cut into the letters as well. So, when it cuts the sticker 5 times, it will consistently make the same errors on each one.
So if anyone could give me any hints on how I could improve this, it would be much appreciated.
SPECS OF CUTTING:
Blade: 45 degree offset
Vinyl: Oracal Vinyl 651
Speed: 150
Force:50
Thank you,
Morg
You do not have the required permissions to view the files attached to this post.