help with cutting a 12x12 puzzle

[Ana]

Hello All,
Ive looked for an answer but was unsuccessful. Was wondering if someone could help me with how to set up my 12"cougar in order to cut a puzzle generated with make the cut. So here are my questions: yes more than one
1) where to I place the blade to cut a full 12 x12 puzzle.
2) what do I put he velocity and the force on?
3) Do I use wysiwig or laser point or even knife point.? and whichever on how?
I would appreciate any help
Thank you

[rachellann]

Try knife point place. you can be about 3-5mil from the right and still cut. with the carrirage all the way to the right slide the mat with the paper on it making sure the paper is center to the blade holder and the set the knife at the front right corner of the paper. the volocity should be about 200 and force about 120 with a multi pass of three fist make sure to have your holder set properly so you can avoid draging because cutting thru mod podge and glue and chipboard will maen more force and passes needed. I would not really try to cut thru all the modge podge and glue and chip board on your first try ay this or make sapmles to try first as you don't want to ruin your project. modge podge has a tendancy to stick to the blades.

[Ana]

Thanks Rachelann,

Appreciate the response. Will try once again lol..
Ana