by Sassycutter » September 19th, 2011, 7:10 am
@ Tyler
I am using the blue clickblade holder. I have adjusted the two screws on top and I cannot get the blade to extend any further. When I put the blade holder in the carriage, it is down in the clamp as far as it will go. Is it possible to adjust the blade holder clamp?
I am getting a good cut, but I am using click setting 1 or 2, and having to use a force of 140 to get it. If this is all normal, I guess I'm good to go. It just sounds very different from a lot of what I read on the forums.
So much paper, so little time....