I've had my machine for about 8 months, however I have barely touched it due to lack of time.
I'm using MTC & the Cougar cutting mat. On my virtual mat I have my text lined up @ approximately the 1/2" mark, well within the cutting area. I'm using the portrait view. I placed my mat according to the Cougar on-line manual (the blade at the corner of my paper),I went offline & set my target.
AFter ( not immdeiately) my Cougar starting cutting it sounded like the carriage return hit the side of the machine ~ like my image was off the mat. Anyway, all the outsides of the text cut fine, but the insides of the e, o, l, etc. are not cut in the correct areas. They are off center.
Any clue to what I'm doing incorrectly?