Page 1 of 1

Line Fill & Knockout - Setup for Engraving

PostPosted: August 5th, 2015, 4:35 am
by MichelleMyBelle
We created a video for the Silver Bullet Pro cutting machine demonstrating engraving. In this video, we show how you can use the Line Fill along with Knockout effects to create a unique item. We also discussed the cutting set up that you'll need when using the Silver Bullet Pro cutting machine.


Re: Line Fill & Knockout - Setup for Engraving

PostPosted: August 8th, 2015, 4:49 pm
by mrsefs
Is it possible to find out where you purchased the 4 x 4 metal tiles or the manufacturer?
Thanks in advance.
Kathy

Re: Line Fill & Knockout - Setup for Engraving

PostPosted: August 8th, 2015, 4:58 pm
by Gigi
Not sure where they got them, but you can get a wide variety of tiles from Home Depot or Lowe's. Home improvement stores are a great resource! I have some fun faux brass tiles that I have been wanting to engrave and use for coasters (note to self - I need to do that!!)

Re: Line Fill & Knockout - Setup for Engraving

PostPosted: August 8th, 2015, 5:00 pm
by mrsefs
I will have to stop in there tomorrow and see what I can find.
Thanks again.
Kathy

Re: Line Fill & Knockout - Setup for Engraving

PostPosted: August 8th, 2015, 5:34 pm
by Gigi
Welcome - you can find all sorts of fun things there to play with ( check out the aisle where they keep the flashing too!) :)

Re: Line Fill & Knockout - Setup for Engraving

PostPosted: August 8th, 2015, 6:21 pm
by mrsefs
I will do that, how do I know how thick the material can be? Do I measure an opening on the machine? I will go look through the learning center to see if I can find something about this. I'm excited to try this.
Kathy

Re: Line Fill & Knockout - Setup for Engraving

PostPosted: August 8th, 2015, 6:37 pm
by Gigi
If you are engraving, the material just has to fit under the machine. We have had users engrave cell phone cases. Tiles easily clear the carriage unit, so no concern about them...

Re: Line Fill & Knockout - Setup for Engraving

PostPosted: August 9th, 2015, 5:26 pm
by scrappydew
mrsefs wrote:Is it possible to find out where you purchased the 4 x 4 metal tiles or the manufacturer?
Thanks in advance.
Kathy



The box for the tiles say Handy Metal Wall Tiles - I found them on Amazon: http://amzn.to/1UxFmTg

The email on the back of the box says handytile@gmail.com Hope that helps you.

Re: Line Fill & Knockout - Setup for Engraving

PostPosted: August 9th, 2015, 5:29 pm
by mrsefs
That is great help, I really appreciate it.
Kathy