Hi Bikeracer,
Thanks. You raise some interesting points. Re: fine tuning, which of the pictures, please? It seemed odd to me that the pink square looks just about perfect, but I couldn’t replicate with an 8.50”x11” sheet of 1” squares. In other words, each of the 48 squares should have looked the same. That’s the mystery I’m trying to solve.
When I said wheels, I meant to say rollers. I’ve cleaned the rollers to make sure there was no adhesive or debris on them. I may switch the out the rollers as a last resort.
Regarding the tables, I think they need to be flat to achieve an accurate and clean cut barring other factors. Can you share details about your setup, please? Do you have a Silver Bullet Pro or Platinum? If SB Pro, do you use the acrylic tables? Does your acrylic table installation look like mine as shown in the pictures?
I’ve ordered replacement rollers and table gussets (I was calling them fins) and I’m hoping one or both solves the mystery.
Any other insights that you have are much appreciated!
Thanks again