Hi,
I have been running SCAL 5 Pro since it came out and have not had any issues. However, my old computer broke and I recently got a new computer and have installed SCAL 5 Pro into it. I have followed the ScrappyDew install and setup videos again to make sure I didn't miss anything, so I installed the Silver Bullet Professional Driver and set the mat to Silver Bullet Professional as well.
I have all of the different blades, 60, 60+, 45, 30 and all of the equivalent detail blades. We have many substrates we cut and I have spent countless hours creating settings for each blade and substrate to go with it. The Blade Offset is one of the most important settings to get right and I rely on this setting to help make crisp cut lines depending on the substrate.
Well, with the new install of SCAL 5 Pro and after adding all of my settings, I have noticed that the Blade Offset has no effect. I can increase the Blade Offset to 2mm or down to 0.2mm and nothing in the cut edges even changes. The cut seems to be the same every time. This is causing major issues with cardstock as the edges are rounded and no longer clean 90 degree angles as before. I thought maybe it might be the computer, so I set up another computer using SCAL 5 Pro and the same thing is happening, the Blade Offset setting is not working.
Has anyone else had a similar issue? Is there something I am missing, is there an additional setting that I have on or off that is keeping the Blade Off Set from working?
Thanks for any help you may be able to provide me.