Silver Bullet Cutters Forum

by **Lisa Lander** » July 29th, 2018, 6:03 pm

Just wondering if it is necessary to re calibrate when starting with new software? i have just up graded to Scal 5 Pro, and would like to know if there is anything i need to do initially ? will be doing the Learning Centre Class, but just wanted to know in advance, thank you :-)

by **Gigi** » July 29th, 2018, 6:43 pm

Yes you should always recalibrate when installing new software - it's just good practice. It's so easy to do that it's worth the minute or two that it takes to be sure your numbers are correct.

Enjoy!

by **Lisa Lander** » July 30th, 2018, 1:57 am

Thank you very much ! :-)

by **Gigi** » July 30th, 2018, 11:05 am

You are very welcome.

by **Braashcj** » November 8th, 2018, 12:29 pm

Hi Lisa
Iâ€™m new to sb and this forum and was wondering if you would be willing
To communicate with me via email about your experience with sb and scal?

Thanks

Silver Bullet Cutters Forum

Home of the Silver Bullet Cutter

Using SCAL 5 Pro

Using SCAL 5 Pro

Re: Using SCAL 5 Pro

Re: Using SCAL 5 Pro

Re: Using SCAL 5 Pro

Re: Using SCAL 5 Pro

Who is online