Page 1 of 1

New Computer

PostPosted: March 20th, 2017, 7:23 pm
by CarolBly
I got a new computer. Of course, now that the old computer has been reformatted, it occurs to me that I had a couple of program files that I missed. I've gone onto the SCAL forum to see what I need to do to get that reinstalled. Do I also need to install something for the cutter, too? Or, is it all embedded within SCAL? Thanks so much,
Carol

Re: New Computer

PostPosted: March 20th, 2017, 11:05 pm
by Gigi
Not sure exactly what you are asking. But if you reinstall SCAL, the drivers will be installed for the Silver Bullet. You will just need to be sure that you have the correct port chosen and you should be good to go. If you get stuck just holler.

If it's any consolation, I had to reformat my computer a few months ago and had no issues getting the SB working once SCAL was installed. Good luck.

Re: New Computer

PostPosted: March 21st, 2017, 8:22 am
by CarolBly
Great. Thanks so much!
Update - Just reviewed Sherri's original email. All is updated and all is good!
C

Re: New Computer

PostPosted: March 21st, 2017, 9:43 am
by Gigi
Ok great. Thanks for letting us know!