by Gigi » July 25th, 2016, 6:47 pm
I am trying to wrap my brain around what you are doing! If you can scan 1/2 at a time (assuming you are doing that on your printer's scanner) I don't see why you couldn't scan in 2-3 pieces - whatever is needed, bring them into SCAL, and as long as you have a large enough machine to cut what you make, make a mat large enough, import the pieces, trace them, and then weld into one pattern. You could match the physical measurements of the material with the pattern to be sure it ends up the right size.
Not sure if this is the right answer - just imagining how it could be done, but have never done anything like that!
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi