Inaccurate Engravings

Inaccurate Engravings

Postby curtisriver2 » May 17th, 2016, 3:49 pm

Greetings,

I make custom rulers by engraving aluminum and have discovered today that all my rulers were coming out too short. Distances varied from 1/16th in to 1/2in over a distance of 24 inches. I only use one pinch roller and do not use a carrier. I run the metal directly through the pinch rollers. I noticed the wheel was gummed up so I cleaned it, and it did not make any difference. It still always came up short. Out of desperation I tried another pinch roller and it worked perfect. Roller 2, 3, and 4 2 work ok. Roller 1 will not work no matter what I try. Does anyone know how to fix it or have ideas to troubleshoot it?

travis
curtisriver2
 
Posts: 5
Joined: April 10th, 2016, 9:07 am
Cutter: 13in

Re: Inaccurate Engravings

Postby LisaH » May 17th, 2016, 4:43 pm

Hi Travis,

I haven't heard of this exact issue before, but I'm sure Tech Support will check with the owner of the company and see if she has or how to address it.

Lisa
User avatar
LisaH
 
Posts: 5433
Images: 8
Joined: May 15th, 2011, 3:33 pm
Location: Georgia, USA
Cutter: 24" SB Pro


Return to General

Who is online

Users browsing this forum: No registered users and 22 guests

cron