by Gigi » March 27th, 2016, 2:40 pm
Need more information!
How do you have the designs laid out on your mat? If you just have one design and are hitting multicut it's going to cut it three times in the same place.
There are a lot of ways to cut a design three times. You can lay it out on your mat three times and then cut once, using either origin or WYSIWYG. Or you can have it once, pick origin cutting so you don't waste room, start it in the front right of your paper and then when it's done with that one, go offline, move the blade to the next spot where you want to cut it, and then cut again.
If it was me, I would probably lay out the three designs on my mat to save the most space and then cut it that way.
HTH.
Happy Easter!
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi