Silver Bullet Cutters Forum

So, when I cut, my blade will cut a section and then move to a totally different section and then back again. It's cutting the design just fine, except that the blade isn't efficient. Does that make sense? I'm looking for it to take less time to cut. Is there any way to do this? (cutting from SCAL) Fondly, Tami

Hey tamihowse Tami.....Just a thought here...have you thought about ungrouping everything and then regrouping .......I'm thinking that's made a difference for me before.......

Is it cutting all the "innies" first? My brain is a little fried from being away (a baby shower out of state), but I think there might be a way to tell scal to cut all the "innies" first.

Pat

Hey Pat pigtailpat actually Brandon programmed the software to actually start cutting all the insides first automatically......are you saying yours isn't doing that????

Yeah, it's really random. It would take a lot less time if it was more systematic. It just goes from one area to another. Fondly, Tami

Have you updated the software?