by kim » April 28th, 2015, 2:42 pm
I am not familiar with car magnet material, but it should be about the same stuff that I cut from Signwarehouse and H&H Sign Supply. The magnet sheets that I cut are a little thick and had to cut on multi pass (I think they were in the vinyl section, but not positive). I will say that I cut them on the roll and that the magnet sheets are slick so I had some skewing when cutting multi pass. Oh, and I cut it when i had my Cougar and the rollers were not as tight as the SB. BUT, I would suggest either putting them on the mat to cut or to put painters tape on the portions of the magnet that will meet the grit pad and where the rollers will be. Just to give it a litle more traction. As for printers, I use an HP InkJet and a Brother Laser printer, then I have a cheap but good little HP Mono Laser printer. Again, I am not familiar with car magnet material but it shouldn't be too much different from the regular magnet sheets. Will add that the difference in the printing of a Laser vs. Inkjet is all in what you want your print to look like. Personally, for artwork, I like Inkjet. For photo, I like Laser.
Mommy to a Silver Bullet 24" , a Black Cat Cougar 24" AND a Foil Master!