Gigi wrote:Here are the very detailed instructions in the learning center.
http://learn.silverbulletcutters.com/si ... rt-tables/
If you have not already applied, I highly recommend it as many of the set up and initial learning questions will be answered there.
Hope this helps.
EDIT: Re-read your post. You have to unscrew the bottom screw in the machine on each side in the front first and replace it with the new screw that will go through the support. Again the learning center will walk you through the steps.
highaltitude wrote:still no approval. Definitley looks like the wrong table IMO.
highaltitude wrote: There are 4x screws that come with the table,but I don't see any empty holes that they would go to? Pretty disappointed that I spent 70 dollars on something that doesn't fit or mount so far. Any info/help would be greatly appreciated.
highaltitude wrote:yeah, been there, unfortunately I guess the registration is not the same as here on the forum, so I am not approved yet to view the information.
Users browsing this forum: No registered users and 129 guests