printing on a full mat

[Ana]

I know how to do print and cut and even wysiwig using mtc. I want to know where to place the blade for a full 12 x 12 cut. For example I want to try and cut a puzzle. But I am not sure how to go about it. Can someone tell me where I am suppose to place the blade for this.. Any help would be greatly appreciated.

Thanks in advance for a quick response.

Ana

[HappyCrafter]

What SW are you using?

[Tyler]

I would get the KNK plugin and just use knifepoint cutting. That is probably your easiest bet. There is more info on how to use it in the learning center.

[Ana]

Thank you, I do have the knk plugin. So I tried it and it worked perfectly. Thank you so much. Never knew what the knifepoint was for. Thanks for your quick response.