I am not getting it through my thick noggin which cut is what....
When I place the blade at the bottom right of my cutting mat and paper edge, and two inches to the left for MTC and hit the origin key to set x and y at 0, I am doing what kind of cutting?
Then, if I want to cut something in the middle of the same piece of paper and I put the blade where I want it to cut, again setting the x and y to 0, is that cut the same as above?
If I ever get my machine calibrated for laser cutting, that will be when I turn on the laser to read the registration marks for a print and cut. Right???
Is any of this making any sense? I know this has been discussed and I apologize for taking time with it again, but I still don't understand. Perhaps there are some tutorials I can read or watch that will clarify this for me. Thank you!!!!