Hi Everyone,
I hope someone could help.
We have a Silver Bullet 24" as our smaller machine just gave up a couple of days ago.
So we plugged in the new one and started to cut.
We bring in our templates from Inkscape (in the menu --> preferences shows this set up as well), everything is the same as with our previous machine.
For some reason this new one cuts slightly wider. The height is correct but the width isn't.
Also, noticed that the curcle cuts are not correct either, when it supposed to meet with the starting point there is a little tear, slightly goes next to the starting point.
Our previous machine was cutting spot on and don't really understand why this one can't do the same with the same set ups.
We use 60 degree blade, settings are .25 and 1.
Nothing has been change.
Thank you for your time and any advice would be highly appreciated!