Cut is consistently 1/2" off
Posted: February 10th, 2018, 5:41 pm
New cutter here....I'm finding my cuts to be consistently about 1/2" off. I've calibrated the laser, done a print/cut, origin and WYSIWYG cuts...everything. Checked my settings and STILL off. My speed/force settings are fine, just the location is off. I'm currently aligning my blade up with the lower, right corner of my page. setting my origin point, going online, and selecting 'origin' cut.
See attached pic. Any suggestions? Thanks in advance!!
See attached pic. Any suggestions? Thanks in advance!!