Hi! Me again
I'm having some issues with the support table. First the instructions in the learning center say to remove the bottom screw - if I do that, the curve of the side pieces absolutely do not line up in a way that will allow me to screw in any hole. If I put it in the top screw, the pieces do not align flush with the side, due to the bottom screw. So which hole is it supposed to go in? If in the top one, the flat table part is actually tilted a little, is it supposed to be? And the support arm is bowed between the two sides, I'm guessing because of that bottom screw and the side pieces not lining up flush. Is it supposed to be like this? Help! Thanks!