by Gigi » September 25th, 2017, 11:48 am
First of all, be sure you have registered the software or you will get random cuts.
But I am guessing what you mean is that you get cuts as the blade is moving from point to point. Is that correct? It could be a lot of things. Be sure your card stock is well brayered to the mat so it is not lifting. The most common reason for that to happen is that your blade is too low and dragging as it moved from node to node or area to area. Be sure to use the setting tool as that will help prevent the dragging. Lift the blade just off the setting tool so it doesn't stick on there.
If your problems is something other than dragging, then please post more or add a picture. But I am going to assume, for now, that dragging is the issue.
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi