Silver Bullet Cutters Forum

What's the trick to mounting the test pen in the Silver Bullet? It's a smaller diameter that the blade or embossing holders. There's not enough range on the clamp to hold the test pen. Should it have a bushing?

Thanks in advance!

The test pen goes in the black plastic holder that came with your machine. You may need to use some tape to hold it in place. It is just to use to get used to where your things will cut on the real mat in relation to the virtual mat. Most people only use the test pen a few times, if at all.

There is a pen tool holder that comes in three parts and holds a wide variety of pens if you want to do writing or drawing. Again - this is just a learning tool that you have the option to use if you choose.

Hope that helps.