Silver Bullet Cutters Forum

Hello all, have been away for quite awhile, glad to be back. I am ready to start re-acquainting with my SB. The problem is, my machines buttons are not responding. I ordered a new set to replace. Has anyone replaced theirs? I looked at the tutorial on how to do it and it looks a bit daunting. I'm afraid to tackle it. Any thoughts? TIA.
JILLIAN

You should be just fine. Sherri said that many people have replaced this piece without issue. I think the number of steps may be daunting, but it really walks you through each little thing. Just take it slow and go at your own pace.

It was so easy, yes....the instructions were very detailed and not nearly as frightening as it looks! Happy to say, controls are better now! I'm excited to start cutting again! Gigi, hope all is well....you and I spoke a few times when I first got started many moons ago. You were so helpful!

Thank you for your kind words - and thank you even more for letting everyone know that changing the part out was not as daunting as it initially seemed. I am so glad you are up and running.

Thanks for letting all of us know. Happy Cutting!