by MeFlick » November 14th, 2016, 8:18 am
First, welcome to the forum. Second, I don't recall having seen anyone post previously about significant problem with the support tables not fitting their cutter. Did you do a search here on the forum to see if you could turn up any other threads? that would be the easiest way to see if anyone else had mentioned a similar problem here on the forum. The search box is in the upper top right corner of the forum screen.
Finally, anytime someone has a hardware problem like this the best way to get it taken care of is to contact the seller from whom you bought it. I am assuming that is Sherri at That's Scrap, Inc. since you have come to this forum. Sherri has always been very good to work with if you have any issues or problems. I would contact her by phone or email to discuss the issue you are seeing with your tables. Photos or videos are helpful for her to "see" what the issues are. Perhaps there was some issue in the set you got and she can best help you quickly resolve the problem. (If it wasn't Sherri, but one of the other distributors they too are always willing to work with the buyer to figure out the issue/problem and get it resolved.) Good luck.
Go Vols!