Hi there!
I've recently purchased the 24" Silver Bullet and have been loving it so far, but I need some help.
I'm making wedding invitations for a friend and have a very specific paper size of 6.875x15.3125 thats already been cut and scored.
My design that I need to cut starts in at .25 from the sides.
I've been using WYSIWYG in SCAL4 but my design is ever so slightly off when it cuts a single piece and becomes a bigger problem when I lay 5 pieces back to back (I bought the commercial cutting mat).
So i switched over to origin point cutting which gave me a super precise cut, but I had to put an invisible box around my design that is the size of the paper that I have. The only problem is that it cuts the invisible box as well.
Is there anyway to keep the invisible box around it but not cut it so that I can have my boarder around my design?
Also, the only reason I stopped using WYSIWYG is because I couldn't make the virtual mat size my exact paper size. It kept rounding up my measurements to 6.88x15.31
If anyone could help THANK YOU in advance!!