Silver Bullet 24" stops during cutting

Re: Silver Bullet 24" stops during cutting

Postby Gigi » August 3rd, 2017, 12:18 pm

If you install the trial version of SCAL, it will install the SB driver automatically. And then in the drop down menu , once the software is installed, you choose the SB as your cutter.

There are no SB drivers for the MTC software - they were never created/upgraded. But you can cut from MTC using the KNK Maxx plug in - NOT the Cougar and not the Zing or the Maxx air. As Melanie said, the Cougar plug in will not work for the SB and that may be why you are having issues off and on. Use the KNK Maxx plug in and see if that helps.

Again, as a way of ruling out issues, install SCAL and try the trial version, realizing you will get a slash through the design, but all else should cut perfectly. You can download the software at Be sure you download the version for the Silver Bullet and the appropriate platform.
Silver Bullet Admin
Silver Bullet Tech Support

Happily using an 18" Silver Bullet Pro
User avatar
Posts: 9825
Images: 190
Joined: May 14th, 2011, 9:53 pm
Location: Southern California
Cutter: 18" Silver Bullet Pro, Foilmaster

Re: Silver Bullet 24" stops during cutting

Postby lizalooks » August 3rd, 2017, 12:31 pm

thank you, I'll give that a try this evening if I have the time. If not, I will report back as soon as I do get it done.

Thanks again ladies.
Posts: 8
Joined: February 13th, 2013, 9:35 am
Cutter: Black Cat Cougar 24"


Return to Silver Bullet Professional Series

Who is online

Users browsing this forum: No registered users and 1 guest