by Gigi » July 29th, 2018, 3:28 pm
Easy fix.
Open SCAL and go to the cutter tab on the TOP menu. Click on it and select "Cutter Settings".
Adjust the registration mark offset down and it will bring it closer to your images. See photo below. You can check in the preview menu and see where the printer margins are and the registration marks so you can be sure they are where you want them before printing. I usually move mine closer, just have not done it yet with the new SCAL 5.
That should help.
You do not have the required permissions to view the files attached to this post.
Silver Bullet Admin/Tech Support
Happily using an 24" Silver Bullet Platinum
Gigi