Good morning everyone! I just got my Silver Bullet the other day and absolutely love it. After a few test cuts with 65# card stock with a double adhesive sheet added to the back, I've found that the following settings work well for me.
V-200
F-50
Passes 2
Offset .2mm
Overcut 2.0mm
The overcut seemed high to me so I did a test cutting one inch squares with an overcut setting in SCAL ranging from 0mm to 10mm. Every square came out exactly the same. No difference in the cuts whatsoever. Now, while I'm happy with the cuts, I'd still like to understand why the overcut setting seems to be ignored. Any ideas?
Also, is there a way to numerically enter the speed and force in SCAL? Sometimes it's hard to get an exact number using the sliders.
Thanks so much for all your help!!
Dan