Page 1 of 1
Can't find the 'Offset' and 'Overcut' buttons on MAC
Posted:
September 10th, 2014, 11:10 pmby Sunehra
I just got my Silver Bullet 18" and I am just delighted. I am experiencing chads and wanted to correct them by setting the offset values and overcut option but when I went to SCAL those options are just not available. I am using a MAC - OSX 10.8.5. Screenshot is attached.
Appreciate your help!
Cheers
Sunehra
Re: Can't find the 'Offset' and 'Overcut' buttons on MAC
Posted:
September 10th, 2014, 11:36 pmby Gigi
Click on the Settings button - that will take you where you need to go for Overcut and Offset. At least that is where it is on the PC so "assuming" it is there for the MAC as well....
Check your file and be sure the chads are not due to too many nodes or misplaced nodes as that happens.
Glad you are enjoying the machine!
Re: Can't find the 'Offset' and 'Overcut' buttons on MAC
Posted:
September 11th, 2014, 2:37 amby Sunehra
Thanks so much Gigi - There was a 'cutter setting' option and I found it. You're a star!
Re: Can't find the 'Offset' and 'Overcut' buttons on MAC
Posted:
September 11th, 2014, 8:54 amby Gigi
You are welcome.