Printing a PDF or similar from Sure Cuts

[intricutz]

I have a chalkboard style save the date that needs to be borderless and I would like to use SCAL and my SB to do this. I have a system to do bordleress with these two components and it works very well. However, I cannot get the image to show up on my print preview, all it shows is a black rectangle. I have done some searching and realize you need the graphic to be vectorized but I don't know where to start?
Thanks,
Martha

[Gigi]

Details on how to do a print and cut which is when you vectorize a graphic, are in the SB Learning Center.

In the Learning Center, go to SCAL>Cutting from SCAL>Performing a Print and Cut.

Hope that helps. Holler if you get stuck.

Just realized you said PDF. You should not need to vectorize a PDF - it should be ready to cut. If for some reason it doesn't come in as clear as you would like, you can just trace it per the instructions.

[LisaH]

You can also open your PDF and save it as a jpg which will allow you to do the PnC a little easier.