I print my art using another program and have my crops 1cm from each corner. I already calibrated and I was able to score, then cut out something very accurately. But this apparently was an anomaly.
Since then, when I finish setting my blade location to the lower right corner area of the page I go to Online.
I then go to Print and Cut. I click OK to go past the printing part since I already printed with crops using another software.
When I click on the next button to start lining up the laser with the crops, the blade moves all the way over toe the left and up until it is off the page. then the buttons don't work and I can't do anything. I end up canceling the PNC in the software and turn the SB off and then on again to clear everything.
I look at the calibration and it still has my numbers. I would like to figure this out because it would help with stuff that I need to do a couple or 3 things to. Any ideas anyone?
It is a nice cutter. I have attached a picture of some popcorn boxes I have made with it. Just need to get more accuracy when scoring and cutting multiples on a sheet.