Thanks for trying to hel, Gigi, but I did already have those and that's what I was following. I read them again and went step by step.
I don't know how many times I had to cancel, shut off the cougar and start over because I didn't press the arrow keys fast enough! Very irritating.
Here are some of the things that are happening:
When I do #3 in Dawn's directions (Calibrate Laser) and it cuts the cross, I position my laser light on the cross, and click on "Finished, my blade holder moves so far off my mat that the pinch wheels are no longer on my mat. Okay, start over. Same thing.
So skip that. Maybe that is my problem but I don't know how to stop it from spitting out my mat. I am using a 12 x 16 mat (which is the smallest mat I have), and the mat size in my SCAL is 8.5 x 11 (same as my paper size)
I finally get it to find all my registration marks, but have to press the origin button on the screen and it moves to the next screen. I have to make sure I press one of the arrows on the screen almost immediately or nothing happens. If I don't press the origin button on the screen, and just press Next, nothing happens.
Okay - so finally get to the end and it cuts out my image (I used basically the same thing Dawn used in the directions).
My cut is about 1/4" diwb from where it should be and about 1/3" to the right.
So, okay, go to Dawn's directions on Fine Tuning the Calibration. Change the values (here I am not sure whether to add or subtract - so just guess and change the #'s) and click on save. Go out of the program, start again and double-check to make sure the new #'s are saved. Yup, they are there.
So do the PNC again. Cuts in the same place as before - nothing changed.
I can't believe I am having this much trouble.
I am going to wait for Tyler to make a video. (Please, Tyler!)
Carol
P.S. Gigi - I would be anxious for you to try doing a PNC (seeing you said you haven't done one yet) and see if you have any problems.