Calibrating the laser

[Deb Za]

Everything I'm reading on this refers to SignCut or MTC. I'm using SCAL3. Do I need to calibrate the laser for this, and if so, where do I enter those numbers?

[Tyler]

Hey Deb Za -

You actually can't calibrate the machine for SCAL, so no worries there. Just know you set the laser about 1.5 inches in from the right of the grid when cutting.

[kathybessey]

So glad the all knowing Tyler was here to help with this! Hoping you are enjoying getting to know your new kitty Deb!

[Deb Za]

Right now I'm pulling my hair out over it, Kathy! (See my post below about it taking off at an angle)

Totally baffled . . .

[Tyler]

moving this thread to software questions.