Silver Bullet Cutters Forum

LisaH wrote:i tried to install the new version Dawn gave us and it keeps telling me I have to activate it, when I put my reg # in it says it isn't correct and won't let me use it...so I guess I will just have to stay with 3.007 for now...

go to the support page send them a note and let them know it happened to be on the last update before this one just include our number and email.

Lisa, I will ask Brandon about it

@LisaH

Brandon says to contact support@craftedge.com and we can help get it activated again

thank you Dawn

You're welcome

It is telling me there was an error and it could not install the exe. file.
Jan

Hi Jan,
Can you try again, maybe after rebooting the computer? Re-download and then try the installation again

Okay, I did reboot my computer and it then let me install, of course I had to fight for an hour or so with my wireless USB adapter before I could get back on line (don't ever replace a NIC card with one of these!) and I finally cut something today and it worked perfectly. I hope it continues to but I will be more careful about downloading upgrades in the future. If it ain't broke, don't fix it!
Jan

Great!

has there been any updates for fixes to scal ?

I am working with Brandon at the moment

Thanks Dawn

bumpin this up!

Ok...May I ask a question..........I've decided I want to start using SCAL more....have been using exclusively Inkscape/Signcut......but am thrilled over SCAL partnering up with Sizzix and now knowing Dawn is working closely with Brandon is just icing on the cake.......Am I right in assuming we can't YET do the print and cut with our Black Cats and SCAL3????? And if that is in fact true....don't laugh at me.....but is it basically a knife point cut we need to figure on doing when using SCAL3??? LOL It's truly been since I've owned my Crapcut since I used SCAL and I loved the program back then!!!

I don't think you can pnc with SCAL I haven't used it forever, I love my signcut, and use it almost all the time.

Hi Penny!

Right now, there is no true knife point or print and cut with SCAL - just WYSIWYG where you set the laser 1.5 inches from the right side.

I did read on here that they are working on PnC. So far it is very accurate so maybe it is very close.

Okie Dokie.......Thanks Tyler....that's "kinda" what I thought....but I thought I would make sure.....I'm still great with my Inkscape/Signcut.....and have been playing with Corel Draw...but wanted to get back into SCAL a bit....I knew Dawn said she's working with Brandon......and that I'm thrilled about!!!! Will continue to play around with SCAL....just will do my PNC with Inkscape/signcut...Thanks bunches guys/gals!!

I have to set my laser at 2" from the right in scal 3, not 1 1/2". Not sure why mine is different, but that is the measurement that allows for a full page cut for me with my lynx

I think that works, I can't remember though for sure, I am sorry, I know it is different than MTC. I am actually going to start playing with SCAL again.