Howdy everyone!
I just purchased a 13" SB and am absolutely astonished at the speed and precision of it! The few sample/fun cuts I first made blew me away. I am definitely looking forward to putting this machine to use. But on to the problem...
I'm mainly using the SB to engrave. I discovered quickly that the BS only engraved the outer edges of the numbers/letters that I put into SCAL. After searching, I found out I needed Inkscape with the Eggbot extension to "fill in" with the hatchfill extension. I have successfully hatchfilled a square, but am unable to make it hatchfill numbers and letters. The software freezes on me every single time. Has anyone else had this issue? I tried downgrading to inkscape 0.48 and eggbot 2.2.3 with the same results. Am I just using it wrong or is there an underlying issue that I am unaware of?
Windows 10 64-bit
8GB ram
Inkscape 0.91
Eggbot extension 2.5.0
Any and all help is greatly appreciated